Simple Sailboat


sailboat-24-wsmGetting Started

Always use your imagination and cialis price 50 mg be creative when building these kids crafts or any others. It's your creation, so be inventive when looking for building supplies — you just may be surprised! When building your project, experiment with new and buy discount propecia different ways of putting it together. The most important thing is to have fun!

 

boat-suplies-blue-tapeFind these or similar supplies!

  • Blue Masking Tape
    (Optional For Customizing)
  • Regular Masking Tape
  • String or Thread
  • Straws or Sticks
  • Milk Carton
  • Plastic Bag

1. Cutting your carton!

Place the carton down on a surface with the open side facing up. Using a ruler, measure and drug viagra mark halfway points at each corner, like you see here. Next, use the ruler to draw a straight line from point to point all the way around the carton. By cutting on this line, you will create a perfectly even boat hull. Now cut your milk carton in half.

marking-carton

hull-untaped-1_2

2. Make a mast!

I like to use straws for my masts. However, you can use just about anything, like a stick, or a pen or pencil. Straws work the best. Start out by covering two straws with tape. This makes them look like real wooden masts. You can add a strip of blue tape at the top for a cool finishing touch.

mast-taped-in-2

mast-tip-23. Begin to rig your boat!

The more time you spend on adding string for your rigging, the more realistic your sailboat will look. I like to start off by making holes at the corners and united healthcare viagra a few more on each side of the sailboats hull. Use a hole punch, and add holes around the edges of your hull. Try to space the holes as evenly as possible if you can.

4.Add a mast-tip!

Another great tip that will make rigging your boat easier is to carefully cut small slots at the top of your mast and canadian pharmacy online on the ends of the boom and viagra uk buy bowsprit. If you aren't using a mast with a flat end (like a pencil or a chopstick) you can wrap the end in tape, like you see here, and once it's thick enough you can cut out the slots.

.

5. Keep rigging!

Start out by tying a long piece of string to one of the corner holes you punched earlier. Next, run it up and cialis 20 mg over the mast, laying through your mast slots. Then pull it down tying it to the opposite corner. Continue this going from corner to corner, side to side and viagra canada online front to back. The most important thing is to use your imagination and be creative!

6.Make the sails!

Cut your sails from a plastic bag. Hold them in place against your mast to see if they will fit, and re-cut new ones or make corrections as needed. Do this until you have the shapes and cialis online without prescription sizes that you like for your sails.

7.Tape your sail!

Place a piece of tape, sticky side up, on a flat surface. It may help to hold it in place by taping the ends down. Now carefully place your sail down the middle of your flipped tape, like so:

sail-tan-vicking-begining

8.Finish the sails!

Now fold the tape carefully in half onto itself. Trim off any excess tape and generic viagra repeat steps six and canadian healthcare viagra seven until your sails are ready to install. You can tie them onto the boat by punching holes along the edges like you see here (or you can simply tape them onto your mast).

sail-tan-finished

9.Finishing touches!

VOILÀ! — a simple sailboat, made from trash! You can add flags, little sailors, and all kinds of cool stuff. The sky is the limit. It's your project, so be creative and viagra buy always use your imagination. The most important thing is to have fun!

sailboat-24-w