TP Flyer


Getting Started

Always use your imagination and real viagra online be creative when building these kids crafts or any others. It's your creation, so be inventive when looking for building supplies — you just may be surprised! When building your project, experiment with new and cialis canada online different ways of putting it together. The most important thing is to have fun!

Find these or similar supplies!

  • Toilet paper tube
  • Regular Masking tape
  • Blue Masking Tape ( Optional For Customizing)
  • Cereal box or some Cardboard
  • Clear plastic container
  • 2 Paper clips
  • 2 Pen caps
  • Straw or an old pen/pencil

tp-flyer-tp--cut-tp-tube1. Cut your TP roll!

Start out by cutting your toilet paper tube at an angle. This is where the windshield will go. If you want you could leave it just the way it is and buy cialis on line have a snub-nosed jet.

tp-flyer-plastic--pt2. Make the windshield!

I made my windshield from a clear plastic container. Find a part of the clear plastic that has a nice shape which you think might make a good canopy. Hold the angled side of your toilet paper tube down onto the plastic and propecia online 1mg trace around the opening. Then carefully cut out your windshield.

This took me a couple of tries to get right. I ended up tracing it a little bigger than the end of my angled tube, and then trimmed a little off until it fit perfectly.

3. Add the tail!

tp-flyer-tape-strawNext, tape on your Flyer's tail. I used a piece of straw about four inches long. You could try using something else like a old pen or even a stick. I taped my tail onto the inside back end, but you could attach yours on the top. Remember to always be creative and overnight canadian viagra try different ways of putting your project together.

4. Add the landing gear!

tp-flyer-landing-gearMaking the landing gear is as simple as bending some paper clips into the shape you like and viagra com taping them onto the bottom of your Flyer's body.

5. Make the main wing!

You can use all sorts of supplies to make the wing and viagra prescription tail pieces. I like to use old cereal boxes. Cut out one side of the box and buy cialis canada lay it printed side down. Next draw and cialis mail order usa cut out your wing and tail section. Try making a few different designs. Then loosely attach them and viagra medication decide which ones you like the best. Remember, it's your project and cialis brand name anything goes!


6.Dry-fit everything together!

I like to dry-fit everything before I put together my project. This is a good time to make any changes or alterations to your design. Anything goes! When you are happy with your plane it's time for the final step...decorating!


7. Dress it up!

If you want to spend a little more time, you can really make your TP. Flyer look nice. This is my favorite part of any project covering it with tape and viagra canada generic dressing it up! I like to use different colored tape to make the project look really cool. I made a design on the wings with my blue tape, and carefully outlined the plastic canopy as well. If you prefer, you could use some colored markers or crayons, even some stickers! As always, try different things and cheap generic cialis have fun.


pt-flyer-finnished-left8. Tape everything together!

OK now it's time to put it all together. For my TP Flyer I used small strips of tape to attach the wing and tail sections together. Then I found two old pen caps to use as my jet engines and viagra online without a prescription attached them under the wing with tape. I also played around with the windshield design.

And there you have it...a cool T.P. Flyer, made from nothing but trash and tape!